CALCULATE WITH CONFIDENCE

Trades & Professional Tools · Surveying & Construction Layout

Station and Offset Point Calculator

Calculate a stake point from a baseline start, baseline azimuth, station distance and signed left/right offset.

Trades & Professional Tools · Surveying & Construction Layout

Enter your project measurements

Measured inputs · visitor-entered product and design assumptions

Use verified measurements, machine or vehicle data, qualified procedure values, field cycle observations, and the stated coordinate or unit convention. Values stay in this browser.

Trade calculator result

—

Enter valid values to see the result.

Your entries are calculated in this browser and are not submitted to 365CALCS.COM.

Quick guide

How to use this calculator

  1. Choose the calculation mode or measurement system that matches the values you actually have.
  2. Enter measured project dimensions and use product-specific coverage, density, yield, resistance, or waste data where requested.
  3. Review the intermediate results before ordering material or applying the result on site.

Calculation method

Calculation method

Baseline point=start+station direction; positive right offset rotates the azimuth 90° clockwise.

The calculator preserves full internal precision and rounds only displayed results. Quantity outputs round up when whole purchasable pieces are required.

Worked example

Worked example

From (1000,2000), azimuth 90°, station 100 and right offset 10 gives (1100,1990).

Baseline point=start+station direction; positive right offset rotates the azimuth 90° clockwise.

Supported inputs

Precision and limits

Survey control and datum boundary

Coordinate and closure calculations use the grid, datum, azimuth, scale, station, offset, observation and weighting conventions you enter. They do not establish legal boundaries, control quality, allowable closure, grid-to-ground corrections, calibration, or the required professional adjustment method.

Planning scope

This calculator supports measurement, estimating, and scenario planning. It does not inspect a site, select a product, certify a design, or replace drawings, specifications, manufacturer instructions, local codes, permits, or a qualified trade professional.

Measured and product-specific inputs

Nominal dimensions can differ from actual dimensions. Verify inside pipe diameters, actual lumber sizes, product coverage, bag yield, material density, conductor resistance, waste, and packaging against the materials used on the project.

Safety and regulatory limits

Electrical, HVAC, structural, excavation, roofing, pressure, lifting, and life-safety work may require jurisdiction-specific calculations and professional approval. Do not use a generic planning result as a code-compliance or safety determination.

Precision and privacy

Inputs accept bounded plain decimals. Calculations remain in this browser and raw entered project values are not submitted to 365CALCS.COM.

Continue calculating

Related calculators