CALCULATE WITH CONFIDENCE

Trades & Professional Tools · Site Work & Landscaping

Silt-Fence Quantity Calculator

Estimate silt-fence fabric rolls, endpoint-inclusive posts and anchoring-trench length from an approved measured alignment.

Trades & Professional Tools · Site Work & Landscaping

Enter your project measurements

Measured inputs · visitor-entered product and design assumptions

Measure using one consistent system. Product coverage, density, resistance, waste, and safety assumptions must come from the actual product data or project specification. Values stay in this browser.

Trade calculator result

—

Enter valid values to see the result.

Your entries are calculated in this browser and are not submitted to 365CALCS.COM.

Quick guide

How to use this calculator

  1. Choose the calculation mode or measurement system that matches the values you actually have.
  2. Enter measured project dimensions and use product-specific coverage, density, yield, resistance, or waste data where requested.
  3. Review the intermediate results before ordering material or applying the result on site.

Calculation method

Calculation method

Fabric length=run×allowance; rolls=ceil(fabric÷roll length); posts=ceil(run÷maximum spacing)+1.

The calculator preserves full internal precision and rounds only displayed results. Quantity outputs round up when whole purchasable pieces are required.

Worked example

Worked example

A 100 m run at 2 m maximum post spacing needs 51 posts before any project-specific corners or reinforcement.

Fabric length=run×allowance; rolls=ceil(fabric÷roll length); posts=ceil(run÷maximum spacing)+1.

Supported inputs

Precision and limits

Site, water and landscape-design boundary

These tools use measured site geometry, field observations, product data, approved application rates, locally selected rainfall and runoff inputs, and contractor production assumptions you enter. They do not establish legal grades or boundaries; prescribe fertilizer, irrigation, drainage, planting, soil, pesticide or structural criteria; locate utilities; approve excavation or equipment operation; or replace drawings, permits, local environmental rules and qualified professional review.

Planning scope

This calculator supports measurement, estimating, and scenario planning. It does not inspect a site, select a product, certify a design, or replace drawings, specifications, manufacturer instructions, local codes, permits, or a qualified trade professional.

Measured and product-specific inputs

Nominal dimensions can differ from actual dimensions. Verify inside pipe diameters, actual lumber sizes, product coverage, bag yield, material density, conductor resistance, waste, and packaging against the materials used on the project.

Safety and regulatory limits

Electrical, HVAC, structural, excavation, roofing, pressure, lifting, and life-safety work may require jurisdiction-specific calculations and professional approval. Do not use a generic planning result as a code-compliance or safety determination.

Precision and privacy

Inputs accept bounded plain decimals. Calculations remain in this browser and raw entered project values are not submitted to 365CALCS.COM.

Continue calculating

Related calculators