CALCULATE WITH CONFIDENCE

Trades & Professional Tools · Plumbing

Sump and Sewage Ejector Pump Calculator

Estimate basin drawdown volume, pump runtime, and cycling from basin geometry, inflow, and pump rate.

Trades & Professional Tools · Plumbing

Enter your project measurements

Measured inputs · visitor-entered product and design assumptions
  1. 1EnterProvide the known values
  2. 2CalculateResults update automatically
  3. 3VerifyReview the details and units
Try an example

Measure using one consistent system. Product coverage, density, resistance, waste, and safety assumptions must come from the actual product data or project specification. Values stay in this browser.

Trade calculator result

—

Enter valid values to see the result.

Your entries are calculated in this browser and are not submitted to 365CALCS.COM.

Feedback

Understand the result

What the Sump and Sewage Ejector Pump is for

Estimate a fill-cycle flow requirement and head-based hydraulic demand from basin and discharge details.

At a glance

See the relationship

The relationship

The formula used here

Drawdown volume = basin area × level change; net drawdown rate = pump flow − inflow.

This is the relationship applied to your inputs. Read the outputs together rather than treating one displayed number as a complete plumbing decision.

Field reading

Use the result as a next check

Enter real project values

Use site measurements, manufacturer information, and the same unit basis throughout.

Read the full result

Use actual basin levels, measured inflow scenarios, and manufacturer pump information for any selection.

Keep the boundary clear

It does not select a pump, establish basin alarms, or approve sewage-system design.

Quick guide

How to use this calculator

  1. Choose the calculation mode or measurement system that matches the values you actually have.
  2. Enter measured project dimensions and use product-specific coverage, density, yield, resistance, or waste data where requested.
  3. Review the intermediate results before ordering material or applying the result on site.

Calculation method

Calculation method

Drawdown volume = basin area × level change; net drawdown rate = pump flow − inflow.

The calculator preserves full internal precision and rounds only displayed results. Quantity outputs round up when whole purchasable pieces are required.

Worked example

Worked example

A 600 mm basin with 250 mm drawdown holds about 70.7 L between switch levels.

Drawdown volume = basin area × level change; net drawdown rate = pump flow − inflow.

Supported inputs

Precision and limits

Water-property assumptions

Where a calculator does not request fluid properties, it models water at 998.2 kg/m³ density and 4,186 J/(kg·K) specific heat. Temperature, pressure, dissolved content, or a different fluid can change real results.

Planning scope

This calculator supports measurement, estimating, and scenario planning. It does not inspect a site, select a product, certify a design, or replace drawings, specifications, manufacturer instructions, local codes, permits, or a qualified trade professional.

Measured and product-specific inputs

Nominal dimensions can differ from actual dimensions. Verify inside pipe diameters, actual lumber sizes, product coverage, bag yield, material density, conductor resistance, waste, and packaging against the materials used on the project.

Safety and regulatory limits

Electrical, HVAC, structural, excavation, roofing, pressure, lifting, and life-safety work may require jurisdiction-specific calculations and professional approval. Do not use a generic planning result as a code-compliance or safety determination.

Precision and privacy

Inputs accept bounded plain decimals. Calculations remain in this browser and raw entered project values are not submitted to 365CALCS.COM.

Continue calculating

Related calculators