CALCULATE WITH CONFIDENCE

Trades & Professional Tools · Roofing

Roof Pitch Calculator

Convert roof rise and run into slope ratio, percentage, angle and rafter factor.

Trades & Professional Tools · Roofing

Enter your project measurements

Measured inputs · visitor-entered product and design assumptions
  1. 1EnterProvide the known values
  2. 2CalculateResults update automatically
  3. 3VerifyReview the details and units
Try an example

Measure using one consistent system. Product coverage, density, resistance, waste, and safety assumptions must come from the actual product data or project specification. Values stay in this browser.

Trade calculator result

—

Enter valid values to see the result.

Your entries are calculated in this browser and are not submitted to 365CALCS.COM.

Feedback

Understand the result

What the Roof Pitch is for

Convert roof rise and run into slope ratio, percentage, angle and rafter factor.

Roof takeoff keeps planes, pitch, edges, penetrations, valleys, ridges, and waste assumptions distinct before they become an order.

At a glance

See the field workflow

1Planes and traced edges
2Slope geometry
3Area and line summary
Read from measured conditions to the calculated field check. Each stage remains a separate assumption you can verify.
Pitch risePitch run

The relationship

The formula used here

Angle=atan(rise/run); rafter factor=√(rise²+run²)/run.

Apply this relationship only after confirming that the measurements, product basis, allowances, and units describe the same project condition.

Field reading

Use the result as a checked next step

1. Measure the real work

Use field dimensions, approved drawings, and actual product or stock information.

2. Reconcile the result

Trace every roof plane and linear component, confirm whether dimensions are plan or slope measurements, and reconcile the summed area with the building geometry.

3. Keep the boundary clear

It does not verify roof condition, safe access, drainage design, structure, product suitability, or installation requirements.

Quick guide

How to use this calculator

  1. Choose the calculation mode or measurement system that matches the values you actually have.
  2. Enter measured project dimensions and use product-specific coverage, density, yield, resistance, or waste data where requested.
  3. Review the intermediate results before ordering material or applying the result on site.

Calculation method

Calculation method

Angle=atan(rise/run); rafter factor=√(rise²+run²)/run.

The calculator preserves full internal precision and rounds only displayed results. Quantity outputs round up when whole purchasable pieces are required.

Worked example

Worked example

A 6-in rise over 12-in run is a 50% slope at about 26.57°.

Angle=atan(rise/run); rafter factor=√(rise²+run²)/run.

Supported inputs

Precision and limits

Roof-system and drainage boundary

Roofing results use measured planes, traced linear components, counted penetrations, product effective coverage, approved fastening/ventilation criteria, local rainfall, and entered drainage capacities. They do not approve a roof assembly, slope, structure, wind or snow resistance, fastener schedule, drainage system, fall protection, warranty, repair, or code compliance.

Planning scope

This calculator supports measurement, estimating, and scenario planning. It does not inspect a site, select a product, certify a design, or replace drawings, specifications, manufacturer instructions, local codes, permits, or a qualified trade professional.

Measured and product-specific inputs

Nominal dimensions can differ from actual dimensions. Verify inside pipe diameters, actual lumber sizes, product coverage, bag yield, material density, conductor resistance, waste, and packaging against the materials used on the project.

Safety and regulatory limits

Electrical, HVAC, structural, excavation, roofing, pressure, lifting, and life-safety work may require jurisdiction-specific calculations and professional approval. Do not use a generic planning result as a code-compliance or safety determination.

Precision and privacy

Inputs accept bounded plain decimals. Calculations remain in this browser and raw entered project values are not submitted to 365CALCS.COM.

Continue calculating

Related calculators