CALCULATE WITH CONFIDENCE

Trades & Professional Tools · HVAC

Evacuation Decay Test Tracker

Calculate vacuum rise rate and pass/fail against a visitor-entered final-pressure limit.

Trades & Professional Tools · HVAC

Enter your project measurements

Measured inputs · visitor-entered product and design assumptions
  1. 1EnterProvide the known values
  2. 2CalculateResults update automatically
  3. 3VerifyReview the details and units
Try an example

Use one consistent unit basis and measurements taken at the stated locations and operating condition. Enter project, manufacturer, fluid-property, pressure-temperature, efficiency, and test criteria from the actual system. Values stay in this browser.

Trade calculator result

—

Enter valid values to see the result.

Your entries are calculated in this browser and are not submitted to 365CALCS.COM.

Feedback

Understand the result

What the Evacuation Decay Test Tracker is for

Calculate vacuum rise rate and pass/fail against a visitor-entered final-pressure limit.

Service measurements become useful when their location and condition are clear. Pressure, temperature, saturation relationship, airflow, runtime, and recovered mass are not interchangeable measurements.

At a glance

See the HVAC relationship

Pressure at isolation (microns)Pressure after hold (microns)Hold time (min)Entered maximum final pressure (microns)

The relationship

The formula used here

Rise rate=(final−isolated initial)/hold time.

This calculator applies that relationship to your entries. Use the formula to check that the units, reference condition, and measurement location make sense together.

Field reading

Use the result as a next check

1. Describe one real condition

Enter values from the same system state, period, unit basis, and measurement location.

2. Read the relationship

Record the exact measured condition, approved refrigerant property source, instrument method, and equipment documentation before using the result as a comparison.

3. Keep the boundary clear

It does not identify refrigerant, set charge, diagnose a fault, authorize pressure or refrigerant work, or replace manufacturer procedures and qualified service practice.

Quick guide

How to use this calculator

  1. Choose the calculation mode or measurement system that matches the values you actually have.
  2. Enter measured project dimensions and use product-specific coverage, density, yield, resistance, or waste data where requested.
  3. Review the intermediate results before ordering material or applying the result on site.

Calculation method

Calculation method

Rise rate=(final−isolated initial)/hold time.

The calculator preserves full internal precision and rounds only displayed results. Quantity outputs round up when whole purchasable pieces are required.

Worked example

Worked example

300 to 500 microns over 10 minutes rises 20 microns/min.

Rise rate=(final−isolated initial)/hold time.

Supported inputs

Precision and limits

HVAC design and service boundary

HVAC results use the measured, design, manufacturer, psychrometric, fluid-property, pressure-temperature, efficiency, and test values you enter. They do not perform or certify Manual J, D, or S procedures; supply ventilation or code defaults; select equipment; identify refrigerant; determine a safe charge; authorize combustion, pressure, electrical, or refrigerant work; or replace approved manufacturer data and a qualified HVAC professional.

Planning scope

This calculator supports measurement, estimating, and scenario planning. It does not inspect a site, select a product, certify a design, or replace drawings, specifications, manufacturer instructions, local codes, permits, or a qualified trade professional.

Measured and product-specific inputs

Nominal dimensions can differ from actual dimensions. Verify inside pipe diameters, actual lumber sizes, product coverage, bag yield, material density, conductor resistance, waste, and packaging against the materials used on the project.

Safety and regulatory limits

Electrical, HVAC, structural, excavation, roofing, pressure, lifting, and life-safety work may require jurisdiction-specific calculations and professional approval. Do not use a generic planning result as a code-compliance or safety determination.

Precision and privacy

Inputs accept bounded plain decimals. Calculations remain in this browser and raw entered project values are not submitted to 365CALCS.COM.

Continue calculating

Related calculators